[OpenIndiana-discuss] etherstub and bridge
anilj at me.com
Sat Feb 25 01:17:24 UTC 2012
I forgot to post the rest of the stuff.
global-zone# dladm show-vnic
LINK OVER SPEED MACADDRESS MACADDRTYPE VID
work0 workswitch0 0 2:8:20:a9:b3:bd random 0
global-zone# dladm show-link
LINK CLASS MTU STATE BRIDGE OVER
igb0 phys 1500 up zbridge --
igb1 phys 1500 up -- --
workswitch0 etherstub 1500 unknown zbridge --
work0 vnic 1500 unknown -- workswitch0
zbridge0 bridge 1500 up -- workswitch0 igb0
global-zone# ifconfig work0 plumb
ifconfig: cannot plumb work0: Interface already in use
So, I have to configure the interface outside the zone and not in the zone itself? Why does it show "unknown"?
On Feb 24, 2012, at 5:06 PM, Anil Jangity wrote:
> I tried to setup a etherstub and a vnic. I then tried to setup a bridge between that and the physical interface, as follows:
> LINK CLASS MTU STATE BRIDGE OVER
> igb0 phys 1500 up zbridge --
> igb1 phys 1500 up -- --
> workswitch0 etherstub 1500 unknown zbridge --
> work0 vnic 1500 unknown -- workswitch0
> zbridge0 bridge 1500 up -- workswitch0 igb0
> The work0 vnic was assigned to the non-global zone. However, once inside the zone, I am not able to hit the default router. I end up with unanswered ARP requests.
> If I do the same thing but instead of using etherstub, if I assign work0 to igb0, it works fine.
> I came across this:
> Is that issue still present?
> Is there an open bug against illumos/OI for this?
> OpenIndiana-discuss mailing list
> OpenIndiana-discuss at openindiana.org
More information about the OpenIndiana-discuss