[oi-dev] Install defaults re. SMB and pam.conf

[Andreas Wacknitz]

Am 26.03.17 um 13:36 schrieb Toomas Soome:
>
>> On 26. märts 2017, at 14:23, Andreas Wacknitz <A.Wacknitz at gmx.de 
>> <mailto:A.Wacknitz at gmx.de>> wrote:
>>
>>
>>
>> Am 25.03.17 um 22:30 schrieb James Blachly:
>>> (I did not get any response on the -discuss list, so please forgive 
>>> the re-posting)
>>>
>>> Speaking as a new OI user here,
>>>
>>> I am using the kernel CIFS/SMB service for the first time (on other 
>>> systems including smartos I am using samba), which is quite 
>>> convenient. However, it did not work out of the box.
>>>
>>> Is there any reason something along the lines of the following 
>>> should not be in /etc/pam.conf in the installer/freshly installed image?
>>>
>>> # Kernel SMB/CIFS service for insertion into /var/smb/smbpasswd
>>> other   password required       pam_smb_passwd.so.1     nowarn
>>>
>>> This seems like a reasonable change that would lower the barrier to 
>>> entry / lower the frustration level for new users at a critical 
>>> point in their go/no go decision.
>> I am not sure about the reasons it is missing in our standard 
>> installation. Probably because not everybody is using smb/cifs and it 
>> might be
>> a security problem. I think the general idea behind it was (during 
>> Solaris times) that it is safer to have as few as possible things 
>> "on" by default
>> and an admin should know what to activate.
>> So an alternative to enable this in /etc/pam.conf would be an 
>> enhanced desription of admin steps after installation (on the wiki 
>> probably).
>>
>> Regards
>> Andreas
>>
>
>
> The problem is that smb setup is not consistent. From one hand you get 
> this mantra “look how easy it is” - which is an lie. What actually 
> should happen is:
>
> 1. creating an share should check if we also need to do smbadm join 
> domain or workgroup; if its workgroup, then the join should also set 
> up the pam entry.
> 2. Set up the default ACL for share. This one is major pain, it is not 
> properly documented, the current default is useless and confusing.
> 3. create /etc/avahi/services/smb.service for SMB.
Toomas, is there any documentation on how to do that? I have installed 
avahi but there is no /etc/avahi folder and I haven't found a 
documentation for it.

Regards
Andreas

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://openindiana.org/pipermail/oi-dev/attachments/20170326/bbe01745/attachment-0002.html>