[OpenIndiana-discuss] Best way to map SAS drives to physicalpositions

[Jeppe Toustrup]

On Mon, Oct 3, 2011 at 19:16, Jason Matthews <jason at broken.net> wrote:
> I wrote a script, it is very rough and would require some tuning for your
> config, but it might solve your problem if your hardware is compatible.
>
> Compatible means, LSI controller and disk shelf that is SES2 compliant,
> supports page code 0xa,  additional element status and sets the element
> index present bit. If your gear does that, then I have a script that could
> help you.
>
> If you meet these restrictions, I will publish it some where along with the
> sas2ircu binary that I lifted from SMC.
>
> j.

I have also managed to write a script to control the fault and
identification lights on the JBOD using SES2 and informations from
this post:
http://www.spinics.net/lists/linux-scsi/msg50273.html

The hardware I am using is a LSI 9201-16e controller, connected
through a LSI SAS6160 switch to a LSI DE1600 JBOD array, so they
should be compatible.

I am very interested in how you are doing things in your script, so
please put it up somewhere.

--
Venlig hilsen / Kind regards
Jeppe Toustrup (aka. Tenzer)