[OpenIndiana-discuss] booting HP xw8600 from ISO

[Harry Putnam]

ken mays via openindiana-discuss <openindiana-discuss at openindiana.org>
writes:

> You usually keep it in AHCI or SATA mode - not IDE. Depends on how the various providers
> define the modes. Consider IDE controller modes 'classic legacy'.

Thanks for the input... I know you are an experienced hand.

I think you might have missed some of the content in thread... a
solaris ISO WILL NOT BOOT when that sata selector part of the BIOS is
set to the one setting containing any mention of AHCI... 

>From a previous post:

[...] part of the xw8600 bios

>> ,----
>> |   SATA Emulation—Sets the SATA emulation mode with the following options:
>> |
>> |    RAID + AHCI–both the RAID and AHCI OPROMs execute. This emulation
>> |    mode is the default and offers the best performance and most
>> |    functionality.
>> |
>> |    Separate IDE Controller–offers standard SATA supports (four ports
>> |    only).
>> |
>> |    Combined IDE Controller–makes the SATA controller look like an IDE
>> |    controller and offers best IDE compatibility (two ports only).
>> `----

If left in the top mentioned setting the ISO will boot up only so far
then drop you in a lame maintenance mode.

Maybe you didn't notice the URL Ed posted where a declaration right
from ORACLE tells you not to leave it set to RAID + AHCI and to set it
to  'Separate IDE' ... I stumbled on that setting by trial error but
Eds' post points to an oracle document that confirms my setting.
h
But, perhaps I'm missing your intent ... would not be unlikely.
Do you mean to set ahci ... somewhere after install?

Is one of the settings above related to your point?  If so, which one?