[OpenIndiana-discuss] ZFS replacement problem

[Damo]

After formatting c3t0d0 run.

 zpool replace tank c3t4d0s1  c3t0d0s1


On Tue, Jun 3, 2014 at 8:05 PM, Michelle Knight <michelle at msknight.com>
wrote:

> Thanks Andreas,
>
> Good suggestion, however, it didn't work...
>
> mich at jaguar:~# zpool replace -f tank c3t4d0s1  c3t0d0
> cannot replace c3t4d0s1 with c3t0d0: no such device in pool
>
> I have also tried exporting and importing the pool, as suggested in
> other forums.
>
> Michelle.
>
> On Tue, 3 Jun 2014 21:01:49 +0200
> Andreas Wacknitz <a.wacknitz at gmx.de> wrote:
>
> > Michelle,
> >
> > Am 03.06.2014 um 20:39 schrieb Michelle Knight
> > <michelle at msknight.com>:
> >
> > > H Folks,
> > >
> > > I've got the following...
> > >
> > > mich at jaguar:~# cfgadm -al
> > > Ap_Id                          Type         Receptacle   Occupant
> > > Condition sata0/0::dsk/c3t0d0            disk         connected
> > > configured   ok sata0/1                        sata-port
> > > empty        unconfigured ok sata0/2::dsk/c3t2d0
> > > disk         connected    configured   ok
> > > sata0/3::dsk/c3t3d0            disk         connected    configured
> > > ok sata0/4::dsk/c3t4d0            disk         connected
> > > configured   ok sata0/5::dsk/c3t5d0            disk
> > > connected    configured   ok
> > >
> > > mich at jaguar:~# zpool status
> > >  pool: rpool1
> > > state: ONLINE
> > >  scan: none requested
> > > config:
> > >
> > >        NAME        STATE     READ WRITE CKSUM
> > >        rpool1      ONLINE       0     0     0
> > >          c3t5d0s0  ONLINE       0     0     0
> > >
> > > errors: No known data errors
> > >
> > >  pool: tank
> > > state: ONLINE
> > >  scan: resilvered 1.70M in 0h0m with 0 errors on Tue Jun  3 18:19:48
> > >  2014 config:
> > >
> > >        NAME          STATE     READ WRITE CKSUM
> > >        tank          ONLINE       0     0     0
> > >          raidz1-0    ONLINE       0     0     0
> > >            c3t4d0s1  ONLINE       0     0     0
> > >            c3t2d0s1  ONLINE       0     0     0
> > >            c3t3d0s1  ONLINE       0     0     0
> > >
> > Your zpool „tank“ consists of sliced disks (note the s1 at the end of
> > the device names)! This is uncommon (only the disk that the system is
> > booted from needs to have a slice because grub needs it).
> >
> > > errors: No known data errors
> > >
> > >
> > > I try ...
> > >
> > > mich at jaguar:~# zpool replace -f tank c3t4d0  c3t0d0
> > > cannot replace c3t4d0 with c3t0d0: no such device in pool
> > >
> > > ... which is what I am reading in countless articles on-line to do,
> > > but it isn't working. I don't know why I'm getting this error, or
> > > which of the two it is complaining about, because if I try...
> > >
> > > mich at jaguar:~# zpool offline tank c3t4d0
> > > cannot offline c3t4d0: no such device in pool
> > >
> > The error message is correct. You have c3t4d0s1 in your zpool, not
> > c3t4d0! When you created your „tank“ zpool you have been using sliced
> > disks, this is unneeded but possible…
> >
> >
> > > So I can't get the drive replaced.
> > >
> > I am not that experienced with it but I guess you could issue
> > zpool replace tank c3t4d0s1 c3t0d0
> > (using the whole unsliced disk c3t0d0).
> >
> > Regards,
> > Andreas
> >
> > > Any help gratefully appreciated.
> > >
> > > Michelle
> > >
> > > _______________________________________________
> > > openindiana-discuss mailing list
> > > openindiana-discuss at openindiana.org
> > > http://openindiana.org/mailman/listinfo/openindiana-discuss
> >
> >
> > _______________________________________________
> > openindiana-discuss mailing list
> > openindiana-discuss at openindiana.org
> > http://openindiana.org/mailman/listinfo/openindiana-discuss
>
> _______________________________________________
> openindiana-discuss mailing list
> openindiana-discuss at openindiana.org
> http://openindiana.org/mailman/listinfo/openindiana-discuss
>